|-- Case Badge Light Kit
-- Price: ~$10.95
-- Page: 1 2
Case badges are familiar to just about
everyone. It lets retailers mark their own computer systems as
well as letting consumers customize logos themselves. Since the
introduction of badges, there hasn't been much fuss or improvement in
the 1 X 1 inch square adhesive badge.
With all the lights going into cases and other
things, the case badge was likely to get this face lift.
over their case badge light kit, which lets the user add some spice
to their badge.
The kit comes with a small square LED
embedded block, molex Y-splitter, blank adhesive sheet and a small
alcohol swap pack.
The backing of the block peels away to
reveal an adhesive. This will allow it to stick to your front
bezel of your case. The included wire will plug into the back
to supply power. We received a red unit, which upon initial
testing proved quite unique:
To get this installed, you will need a
drill with a 1/2" bit. The way the kit works is that this
block will fit over and into the hole that your drill:
Once you have it stuck on tightly, take
any paper backed case badge and stick it on. This kit will
only work with thin paper backed badges, using metal backed version
will not let the light shine through.
After applying, you should have
something like this: