|-- A Closer Look
-- Page: 1 2
I am sure everyone wants to see the individual components of this case, so this page is dedicated to
that. By the way, this case is part red tinted and part clear, just to show the different colors, so do not adjust your monitors :) Note, the pictures were taken without any direct light so that you can see the panels, in full light they are extremely clear and hard to photograph.
Here is the bottom and top, respectively. The panel on the left with the little
speaker hole is the bottom panel.
Here are the drive supports. This case is 4 5.25 external bays and 2 3.5 external bays while leaving a lot of room for
Here is the rear and front panels. The rear panel is the only metal part on the case. I am not sure if that is good or bad, but it is a lot easier to install your cards and
motherboard. The front and rear panel have cut-outs for 80mm fans.
Here is the right side of the case and the Motherboard tray.
Here is the left side of the case. You can see that Sunbeam has copied one of my cases :) and installed 2 fan cut-outs across from the
motherboard and CPU. These are both 80mm in size.