Putting it Together
you get the hole drilled, line up the switch so it's centered and
mark where one of the alignment keys on the switch is and then file
about a 1\8" grove for it in the bay cover so the switch won't
rotate around in the bay cover.
Then decide if you are going to attach the light with the
double-sided sticky foam pads or with screws.
There are screw tabs on either end of the light as you can se
form the pic.
I applied the foam pads to either end and stuck it to the
bottom of the case right next to the side panel.
Then run the leads for the switch out the hole where the bay
cover will go and attach them to the switch.
Pop the bay cover into place; plug the molex connector into a
power connector and fire up your computer.
if you have a window in the side of your case you can enjoy the
glowing in the dark like this.
The Neon Light kit is another outstanding
product sold by pcMods. It
took all of 10 minutes to install the light.
They have improved this light over the past products by wiring
everything all up for those of us who aren't electrical engineers.
Itís pretty much a plug and play installation other than the
drilling of the hole in the bay cover or wherever you decide to put
sure you head over to PCMods
and check out the other fine products sold by them.
this Review in the Forums >
Get some more gear at