| --
Measuring the Workspace
First
off you need to decide where you are going to put the on-off switch
for the light.
I decided to put it in a 5 1\4" bat cover that will be
getting a bay bus installed in it at a later date.
The switch is round as you can see and requires about a
3\4" hole.
You need to draw a line across the center of the bay cover.
Draw a couple of pencil marks on the
edges of the cutout template that align with the centering lines on it
and pull the paper off the back and stick it to the bay cover.
Then proceed to drill or cut out the hole with a utility knife.
A 3\4" drill bit should work just fine but the biggest but
I had was 9\16's, so I proceeded to drill a 9\16's hole and enlarge it
using my Dremel tool.
Putting
it Together >
< PCMods
Neon Light Kit
Get some more gear at
the buy.com
computer store ! |
