|-- Close up of the P.D.P
-- Page: 1
Well it's time to look at the business part of the Power Down
Protector. The P.D.P is approximately 2 inches square when including
the tab portion with the mounting holes and approximately a half inch
tall. Here is what it looks like from the top, back, and bottom. The
top of the Power Down Protector is silk screened with the connector
names so its pretty easy to identify which is which. The second
picture shows how the internal components are attached to the anodized
aluminum case with two plastic "rivets".
In the last image above, you will see the
jumper settings to set the amount of time that the fan(s) will stay on
after you shut your computer off. The next two images are the left and
right images of the connectors.
Here is a nice feature if you happen to
wear off the silk screening on the top of the P.D.P. The PCB (Printed
Circuit Board) has the connector names printed underneath the
connectors, although its kind of hard to see them.