|-- What are those Green Things?
-- Page: 1 2
If you haven't noticed, green and silver is the
theme here. Besides the green plastic stabilizer pieces,
there's also green drive locking notches on the drive cages.
Ok, before you go bezerk on the color
scheme here, those notches are pretty damn cool if I must say. To
get your drives in place, you won't even need a screwdriver. Just
push your drives in, push the green notches forward and lock them
down. That's all you need to do!
The middle green one you see there is in
the lock position, while the ones above and below are open. This
makes it easier to remove and install drives if you're constantly inside
your case. And I thought the drive rails on the Enlight 7237 was
easy to use!
Here's the 3.5" cage with the green
locking notch also. Notice the extra space underneath the cage for
another drive to be installed. The cage's bottom has these
pre-drilled holes to get some hot air out. You can opt to put
another drive there, or do some modding and get a fan under there for
some extra cooling for your drives.
Along with the common bag of screws and
accessories, the case comes with toolless expansion slot covers.
Convenience is the key word for this case I guess.
The nipples for the case are a bit
different too. Commonly you get the brass ones that you need to
screw into the motherboard tray. By the way, this case DOES NOT
have a removable tray, I'll take my remark about convenience away
now. Anyway, the motherboard stand off for this case uses these
different nipples that slide into the tray instead of screwing. At
least that part is easy! I always have trouble with the brass ones
staying in place while I turn it.