| --
Installation
To start off the
installation, we apply the copper shim that was supplied to us in
the package, onto our CPU.
We tested this cooler
out on our rig:
- MSI K7T ProA
- AMD Tbird 800 Mhz Socket A
We did not use the supplied 3pin-4pin
adapter. From what E-Compuvision suggested, due to the fact
that some older boards have a lower3pin voltage rating, the
Delta fan may prove to be too much. Our board supported it just fine
: )
Here is our set up:
Applying the copper shim is real easy,
just line up the holes and your set.
Clip the heatsink to the notches on the
board and screw down the clips and your set! Here is a diagram
from E-Compuvision to help you out:
No need to break out that flat headed screwdriver!
Conclusions
>
< E-Compuvision's
CV Chill 370/462 |
