|-- Electronic Lock with Key Card
-- Page: 1 2
We have something a
bit more advanced for you today to work on for you computer.
This guide will allow you to replace your power button with a
perforated coded card, giving the possibility to ďlockĒ your computer.
People wonít be able to turn it on nor off via hardware. If you
want to power up or shut down your PC, all you have to do is insert
the card and take it out. The size of the coded card depends on
the size of the materials and you. Iíve chosen to use an optic
reading circuit together with a perforated card containing a code
because all youíll see is a little slit wherever you put the reading
The reading circuit can be away from the circuit that is in charge
of the lock. With a coded card you donít need to remember or
type numbers compared to a numeric pad. Having only some ICs you
can have a huge number of possible combinations. The circuit Iím
about to describe has 255 possible combinations, Iíve asked in the
this is what most people requested.
This is an “Advanced” guide, you may not be able to get the same parts
as I did. The locking circuit has already
been tested and works with all the parts listed. If you cannot get the same parts, I recommend having a multi-tester,
oscilloscope is going to be the best choice since you’re going to be able
to see exactly what’s happening.
It’s important to read everything in this guide, so if you’re having
some troubles you may be able to check what’s wrong. Knowledge about
electronics and digital logic will definitely help you.
You will also have to find an optoisolator that fits the circuit and your
(Voltage and Amperage), since the original project I did used a relay and I couldn't
test it with an optoisolator.
Don’t be scared by all you’ve just read, keep reading.
- 1 14015
- 2 14049
- 1 14081
- 1 14082
- 1 14106
- 5 Resistor 1K2O 1/4W
- 4 Resistor 100KO 1/4W
- 1 Experimental PCB
- 2 IC Socket 14 Pins
- 2 IC Socket 16 Pins
- 3 Capacitor 1nF
- 4 Phototransistor Brand: Kingbright Ė Model: L-32P2C
- 4 Infra Red Emitting Diode Brand: Kingbright Ė Series: L34
- 1 Optoisolator (You might also need a resistor for it)
- Pen or Pencil
- Soldering Iron Kit
- Hot Glue or any Epoxy
- Plastic Box
- Piece of Wood
- Card, you can use an old credit card or a phone card.
- Screws, Nails, or anything to make a rail for the card.