Putting it Together
Once you get the hole drilled, line up the switch so it's centered and mark where one of the alignment keys on the switch is and then file about a 18" grove for it in the bay cover so the switch won't rotate around in the bay cover. Then decide if you are going to attach the light with the double-sided sticky foam pads or with screws. There are screw tabs on either end of the light as you can se form the pic. I applied the foam pads to either end and stuck it to the bottom of the case right next to the side panel. Then run the leads for the switch out the hole where the bay cover will go and attach them to the switch. Pop the bay cover into place; plug the molex connector into a power connector and fire up your computer.
Now if you have a window in the side of your case you can enjoy the glowing in the dark like this. :o)
The Neon Light kit is another outstanding product sold by pcMods. It took all of 10 minutes to install the light. They have improved this light over the past products by wiring everything all up for those of us who aren't electrical engineers. Itís pretty much a plug and play installation other than the drilling of the hole in the bay cover or wherever you decide to put it.
Make sure you head over to PCMods and check out the other fine products sold by them.