Both sides panels are secured with a spring loaded thumb screw. Twist it a few times and then pull it to pop the side panels loose.

The side panels are lined with sound dampening foam. It makes the panels a bit heavier, but not by too much.

As seen earlier, the motherboard, I/O panel and PSU are switched around. With this orientation, the side panel you normally would open to get access to your system is now on the other side.

The bottom of the case contains three areas for added ventilation.

The power supply and hard drives will be installed in the bottom area of the case.

Separating the bottom area with the top area are a couple of holes to allow the cables to reach. There is a expansion card beam that runs vertically over the motherboard area.