Here are some troubleshooting items to look through if you run into problems.

THE ACT/LINK LED DOES NOT LIGHT:

• Try removing and reattaching the LED at the end of the wire if you have it off-board. You probably have it in backwards.
• Check your connections to make sure it was soldered in completely.

THE CARD DOESNT SHOW UP IN SYSTEM DEVICES/STOPS THE SYSTEM FROM STARTING UP NORMALLY:

• Check to see if anything is shorting
• Check to see if the card is pushed in all the way
• If the above doesnt work, the card is most likely dead. Accept it as a loss, and move on

I BOUGHT A NEW CARD THAT IS DIFFERENT THEN WHAT I HAD BEFORE, HOW DO I SET IT UP: Go here (I DO NOT PROVIDE SUPPORT FOR THIS!)

The completed setup sitting in the messy system:

Holding the external LED, the picture doesnt show the light being on, but it works. :D

Comments/Suggestions, you can email me at sgtpmv@hotmail.com.