Note: This is a user submitted guide by AMD_Junk13.

This all started because I liked the design of the new LIAN-LI cases but not the outside of them. So I thought why not take my Xaser II that I like very much and just redesign it.

To get started, I needed to strip everything down.

After some rivet drilling the parts lined up.

Removing drive cage mounts and test fitting the top on the bottom.

Some times little pieces must go to make it work... this was one of them.

Test fitting of the MB and frame work. A bit tight on the drives but a good fit. And no the cross braces are not mounted yet, that's why they are just hanging there.

Just a back shot to show how it will all lay out. I'm very happy so far with how it's working out.

This will be the new drive cage I'm using for my HD's. It is out of a gateway. The locking buttons will be dyed and the metal painted.

This is a pic of the heat shield I will install between the HD/PSU section and the MB. I cut it off the same case I got the cage.