Throughout this mod I will explain to you in greatest detail how to put a Playstation 1 into your case. It doesn’t require much but comes out looking great. Before beginning, you will need the following:
- Ribbon (optional)
- Dremel or any cutting tool
The first step is to get a Playstation, there are a few different models that were released by Sony. Each of these models vary a bit in design internally, we will be using the 9001 model for our modification.
The first portion of the mod is to take apart your Playstation. Please note doing so will definitely void your warranty if it is still valid. Flip your system over and locate the screws on the back. Unscrew them and carefully lift off the front cover.
There should be a black drive situated near the middle. Remove that and place it on the side for later use.
Next you will want to unplug the power supply cord from the main board.
Unscrew the screws pictured below with the red dots.